RC-Monster Forums - View Single Post - What gearing for crt.5 on MM/VXL motor/ 3s?

R00ST · 09.02.2008, 06:58 PM

I would like to keep temps down as well as squeeze runtime out of my 3s 5000mah packs, which was my thinking for the 12 tooth. If I run 4.1-4.25 tall tires for offroad I would assume this will be about the same mph (40) compared to the 3.5 stock tires considering the ballooning factor (the 1/8 buggy tires will not balloon that much as the sidewall is so thin).

Anyone run this same setup on the crt.5 I have heard a lot of people say this is a good combo, but cant seem to find anyone that actually runs it!

	(#2)
R00ST RC-Monster Carbon Fiber Offline Posts: 284 Join Date: Jun 2005	09.02.2008, 06:58 PM I would like to keep temps down as well as squeeze runtime out of my 3s 5000mah packs, which was my thinking for the 12 tooth. If I run 4.1-4.25 tall tires for offroad I would assume this will be about the same mph (40) compared to the 3.5 stock tires considering the ballooning factor (the 1/8 buggy tires will not balloon that much as the sidewall is so thin). Anyone run this same setup on the crt.5 I have heard a lot of people say this is a good combo, but cant seem to find anyone that actually runs it!