RC-Monster Forums - View Single Post - e-revo conversion glitch

E-Revonut · 09.05.2008, 11:27 PM

This is one gremlin I'm very happy to say I haven't had to deal with yet. I run with Spektrum DSM2 (DX3R tx SR3100 rx) and haven't had any problems. I have no first hand experience with this so I'm not sure I can help but I will try. Any wire passing current through it has a field around it. A trick often used to eliminate this field is twisting wires around each other. I have seen servos that have the wires twisted/braided. Any wires that are neer your rx you could try this with, esc/servo wires plugging into rx.

Good luck, hope you get it figured out.

	(#5)
E-Revonut RC-Monster RC8T Offline Posts: 2,554 Join Date: Jan 2008 Location: Syracuse, New York (Camillus)	09.05.2008, 11:27 PM This is one gremlin I'm very happy to say I haven't had to deal with yet. I run with Spektrum DSM2 (DX3R tx SR3100 rx) and haven't had any problems. I have no first hand experience with this so I'm not sure I can help but I will try. Any wire passing current through it has a field around it. A trick often used to eliminate this field is twisting wires around each other. I have seen servos that have the wires twisted/braided. Any wires that are neer your rx you could try this with, esc/servo wires plugging into rx. Good luck, hope you get it figured out. RC-Monster RC8T 1515 2.5D/MMM/5s RC-M 4500mah SC10 MMPro 13.5T 2s NeuEnery 5000mah RC18T Mamba 25/5400kv 2s lipo + 6s NiMh