RC-Monster Forums - View Single Post

BrianG · 09.08.2008, 02:48 PM

Other than the two disadvantages you noted, not that I can think of.

Most people grab power for the BEC right at the Deans connector, which can make wiring look a little messy. If you don't mind taking the ESC apart, you could solder those wires directly on the power input on the ESC. You can make wiring a bit cleaner that way.

	(#2)
BrianG RC-Monster Admin Offline Posts: 14,609 Join Date: Nov 2005 Location: Des Moines, IA	09.08.2008, 02:48 PM Other than the two disadvantages you noted, not that I can think of. Most people grab power for the BEC right at the Deans connector, which can make wiring look a little messy. If you don't mind taking the ESC apart, you could solder those wires directly on the power input on the ESC. You can make wiring a bit cleaner that way.