RC-Monster Forums - View Single Post - Not impressed with RC-M pinions

Unsullied_Spy · 04:54 AM

I figured that since it was supposed to be hardened steel it would be fine, I'm not sure what's going on with it. My camera takes poor close-up shots but I'll try to get a picture to show you the obvious wear on the gear.

EDIT: It turns out my cell phone takes better close-ups than my Nikon

It isn't the best picture, but you can clearly see that it is worn out. With the power of my Neu I probably would have stripped that part of the gear off had I finished off the battery pack I was on.

	(#4)
Unsullied_Spy RC-Monster Titanium Offline Posts: 1,609 Join Date: Aug 2008 Location: Bozeman, Montana	10.02.2008, 04:37 AM I figured that since it was supposed to be hardened steel it would be fine, I'm not sure what's going on with it. My camera takes poor close-up shots but I'll try to get a picture to show you the obvious wear on the gear. EDIT: It turns out my cell phone takes better close-ups than my Nikon It isn't the best picture, but you can clearly see that it is worn out. With the power of my Neu I probably would have stripped that part of the gear off had I finished off the battery pack I was on. Last edited by Unsullied_Spy; 10.02.2008 at 04:54 AM.