RC-Monster Forums - View Single Post

lincpimp · 10.07.2008, 09:59 PM

Make sure none of the cells have puffed. Also check individual cell voltages thru the balance port. If they are wildly off you may consider charging the cells individually thru the balance port.

I would suggest a low charge rate, .5 amp max. If you can get the cell voltages over 3v each you should be fine. Be careful.

I have successfully resurected cells that were below 1 volt. Took a while.

What brand is it?

Also, set the MM lvc manually, I do not trust the auto lipo setting. Make sure your setting refelects 3.1-3.2v per cell.

	(#6)
lincpimp Check out my huge box! Offline Posts: 11,935 Join Date: Aug 2007 Location: Slidell, LA	10.07.2008, 09:59 PM Make sure none of the cells have puffed. Also check individual cell voltages thru the balance port. If they are wildly off you may consider charging the cells individually thru the balance port. I would suggest a low charge rate, .5 amp max. If you can get the cell voltages over 3v each you should be fine. Be careful. I have successfully resurected cells that were below 1 volt. Took a while. What brand is it? Also, set the MM lvc manually, I do not trust the auto lipo setting. Make sure your setting refelects 3.1-3.2v per cell. Alot of Savage parts for sale!!!