Quote:
Originally Posted by clowkoy
This is from Lutach's picture.
I see now where the problem comes in: if any two of the connectors will touch the heat sink, a short can occur. |
Exactly. The heatsink is mounted to the board using non-electrically conductive thermal epoxy, and the FETs it's mounted to do not have any exposed metal.
CC made a good change in V3 to have wires soldered to the battery side of the board.
SH Z-Car, Custom Crawler, 8s Savage,
12s XTM XLB 1/7 buggy,
4wd 4-link rear/IFS Pro4 truck,
Custom Hyper 10 Short Course,
Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz