RC-Monster Forums - View Single Post - Dead V3

killajb · 11.04.2008, 01:48 PM

I haven't had a chance to run my MMM yet (away for a business trip) but I did bring it along. I mentioned this in another thread, but I was amazed to find how sharp the edges of the circuit board were. The insulation on the fan, receiver out, and switch wires can easily be cut and cause shorts. A suggestion to Castle going forward would be to add another 3mm of clearance on the side of the case where these wires pass the circuit board and perhaps cover them with shrink wrap as well.

	(#12)
killajb RC-Monster Carbon Fiber Offline Posts: 247 Join Date: Dec 2007	11.04.2008, 01:48 PM I haven't had a chance to run my MMM yet (away for a business trip) but I did bring it along. I mentioned this in another thread, but I was amazed to find how sharp the edges of the circuit board were. The insulation on the fan, receiver out, and switch wires can easily be cut and cause shorts. A suggestion to Castle going forward would be to add another 3mm of clearance on the side of the case where these wires pass the circuit board and perhaps cover them with shrink wrap as well.