I believe a few of you guys have seen my truck. Its not done, but closer..

Basically the widening mod, is using LS10 parts, they all fit no problems right into the normal stuff, but are probably .3 in at least wider per side (dont have the truck in front of me now...) And are ALOT stronger

You can run the upper arms if you wish, just need some lunsford or something turnbuckles that are longer, I just went away with them (no pics of that yet)







Still need my turnbuckles, drive shafts, bearings, and all that stuff. But once I figure that out, I know I think it was hpi nitro mt2 17mm adaptor hubs made by new era fit. So bam, and done!

Any questions, just ask