RC-Monster Forums - View Single Post

George16 · 02:52 AM

Well, it lasted a few weeks

. I was into my second pack when the truck just stopped moving. I went over to pick it up and when I removed the body, there are no lights lit on the MMM. No smoke or cogging. This is my second time running the revo conversion I built a few weeks ago. I used the long-shanked pinions I bought from TeknoRC instead of the elektri-clutch.

Here' my setup:
Revo conversion
5S 25C Neuenergy 5000mah lipos
38/17 spur/cb
stock diffs
locked 2nd gear tranny
mechanical brakes

I'll be sending it off to CC tomorrow. I'm not even going to bother opening the case or doing anything at all. I'll just let them do the troubleshooting/repair. It won't even energize the rx so probably the BEC died.

Back to running Luciano's ESC on the Gmaxx until I get the replacement

.

	(#1)
George16 Supermaxx Offline Posts: 2,031 Join Date: Oct 2007 Location: Earth	Another dead V3 - 11.23.2008, 02:51 AM Well, it lasted a few weeks . I was into my second pack when the truck just stopped moving. I went over to pick it up and when I removed the body, there are no lights lit on the MMM. No smoke or cogging. This is my second time running the revo conversion I built a few weeks ago. I used the long-shanked pinions I bought from TeknoRC instead of the elektri-clutch. Here' my setup: Revo conversion 5S 25C Neuenergy 5000mah lipos 38/17 spur/cb stock diffs locked 2nd gear tranny mechanical brakes I'll be sending it off to CC tomorrow. I'm not even going to bother opening the case or doing anything at all. I'll just let them do the troubleshooting/repair. It won't even energize the rx so probably the BEC died. Back to running Luciano's ESC on the Gmaxx until I get the replacement . Castle Neu 1520 on 6S LiPo Powered Gmaxx (Nitro Killer) Predator with OS .21TM Supermaxx with Mach .26 Revo with OS .18TZ Kyosho ST-RR Conversion Ofna CR with Tekin ESC/Motor (2) Last edited by George16; 11.23.2008 at 02:52 AM.