RC-Monster Forums - View Single Post - Project Super-VBS-CF-Gorillamaxx!!!

jordan... · 12.11.2008, 05:29 AM

So im having a hard time finding a replacement pin for the cvd. I was going to use a drill bit, but then found out that the shank, the end bit, is not hardened steel. Do you guys think that it will hold up if it is just plain old steel, not hardened steel?

	(#355)
jordan... one.five.two.seven Offline Posts: 427 Join Date: Oct 2007	12.11.2008, 05:29 AM So im having a hard time finding a replacement pin for the cvd. I was going to use a drill bit, but then found out that the shank, the end bit, is not hardened steel. Do you guys think that it will hold up if it is just plain old steel, not hardened steel?