RC-Monster Forums - View Single Post

Dafni · 06:23 AM

Never had problems with MIP either. Their setscrews work just fine, but when I have the opporunity, I swap the setscrews with some selfmade ones. I just take long setscrews and make them pointy on a lathe. Never did this in quite a while, though.
I have MIP cups in the centerline of my most used truck, un-modified, and never had a problem there.
Nick, just make sure you tighten the set screw on the flat surface of the output shaft.

	(#21)
Dafni RC-Monster Mod Offline Posts: 2,487 Join Date: Feb 2005	11.21.2005, 06:22 AM Never had problems with MIP either. Their setscrews work just fine, but when I have the opporunity, I swap the setscrews with some selfmade ones. I just take long setscrews and make them pointy on a lathe. Never did this in quite a while, though. I have MIP cups in the centerline of my most used truck, un-modified, and never had a problem there. Nick, just make sure you tighten the set screw on the flat surface of the output shaft. Last edited by Dafni; 11.21.2005 at 06:23 AM.