[lincpimp]

Hmm, so you wanna sell me the dx6?

I just received my clod based crawler in the mail. Also got a sweet deal on 4 rcwd knuckles, integy hd gears, steel skids, servo mounts and axle braces. He even threw in adj motor mounts and full bearings for the axles.

Any chance of a link to the bec wiring schematic? I am guessing that it is slightly more involved than just wiring the + and - on the servos to the bec output and let the esc internal bec power the rx. I read somewhere that the servos need to share ground (or something like that) with the rx in order to work correctly.

I plan to run a 8711 for the front steering and a 9100t for the rear. So I figure the power requirements may be a bit high for those 2.