RC-Monster Forums - View Single Post - Jato Roller came in planning on putting a remote start on it

Gee · 01.14.2009, 02:17 PM

Hi guys, I could use some guidance as to what to look for as far as an esc to use in this project. It will be used with a 2s 7.4 lipo, a ccbec will be used to provide power from it to the electronics in the jato. It will be connected to a brushed 380 motor to crank the 3.3 motor but it will also be providing the glow plug with power at the same time. All I know is I need a brushed esc with a small foot print but not sure as to what amp size or any other considerations I should keep in mind. Thanks for the help. Again.

	(#9)
Gee A Horse's Ass Offline Posts: 1,065 Join Date: Oct 2007 Location: Spokane WA	01.14.2009, 02:17 PM Hi guys, I could use some guidance as to what to look for as far as an esc to use in this project. It will be used with a 2s 7.4 lipo, a ccbec will be used to provide power from it to the electronics in the jato. It will be connected to a brushed 380 motor to crank the 3.3 motor but it will also be providing the glow plug with power at the same time. All I know is I need a brushed esc with a small foot print but not sure as to what amp size or any other considerations I should keep in mind. Thanks for the help. Again.