RC-Monster Forums - View Single Post - E-Raze Buggy Conversion

Raze ST Truggy · 02.15.2009, 09:44 PM

This is just the initial stages of this buggy. The battery tray is pop rivited (no sharp surfaces) togeather around the sides and bottom. I want to coat the whole tray with something like this :

http://www.caswellplating.com/aids/plastidip.html

It was mentioned in another thread, I think I'm going to try it out and see how it works.

I also need to make real ESC and rx mounts. The zip ties are only temporrary I needed to give this thing a rip to see how it ran.

-Brian

	(#3)
Raze ST Truggy RC-Monster Carbon Fiber Offline Posts: 159 Join Date: May 2008	02.15.2009, 09:44 PM This is just the initial stages of this buggy. The battery tray is pop rivited (no sharp surfaces) togeather around the sides and bottom. I want to coat the whole tray with something like this : http://www.caswellplating.com/aids/plastidip.html It was mentioned in another thread, I think I'm going to try it out and see how it works. I also need to make real ESC and rx mounts. The zip ties are only temporrary I needed to give this thing a rip to see how it ran. -Brian