RC-Monster Forums - View Single Post

highflier · 12.10.2005, 09:45 AM

One side has a circuit board, I would not remove that side, However if the otherside would help I would go for it (The bottom side). That said, why you think they are thick, The foam pad is really quite thin, Thus I doubt it will meke the diff between no fit and fit.

You would be better off getting a ray gun that enlarges thinks and use it on the whole truck. LOL

Highflier

	(#11)
highflier Emaxx- FLM wannabe Offline Posts: 253 Join Date: Oct 2005 Location: PA	12.10.2005, 09:45 AM One side has a circuit board, I would not remove that side, However if the otherside would help I would go for it (The bottom side). That said, why you think they are thick, The foam pad is really quite thin, Thus I doubt it will meke the diff between no fit and fit. You would be better off getting a ray gun that enlarges thinks and use it on the whole truck. LOL Highflier E-maxx Brushless HPI MT Racer Brushless Associated rc10t brushless Associated B3 Brushed Tons of airplanes and a few Heli's