Quote:
Originally Posted by TexasSP
Make sure when it goes to powder coating the edges are as clean as possible and try to get rid of hard corners. This is the only downside to powder coating is the it can chip in rough areas and hard corners.
Anodizing would work well too. I have a local guy that anodizes any color for 100 per batch, as much as you can fit.
|
Good to know...thanks for the info, I will keep this in mind!
1. MBX-6 T8 1900KV, RX8 ON 4S
2. MBX-5T 1520, MMM ON 5S
3. MBX-5 ONROAD CONVERSION 1515, MMM ON 5S
4. MRX-3 ON ROAD CONVERSION 1512, MMM ON 6S
5. TEN T 2650 T8, MMP ON 3S