RC-Monster Forums - View Single Post

Rtsbasic · 12.29.2005, 07:01 AM

captain harlock, thats a good idea..only problem is then I have no rear bumper, and even though the car weighs quite a bit it still likes to wheelie once in a while. I'm thinking about fabricating a new rear bumper out some scrap alloy so I guess I could design it to go further back, which would allow the RCM heatsink to sit there.

The epoxy idea is what I was going to run with, but I don't really like the idea of getting that stuff near my motor, I tend to naff up things like that.

Thanks for the suggestions guys :) I am just a bit concerned about the winding because every other picture of a feigao i've seen didn't have the winding poking up there, normally its flush with the rest of it.

	(#7)
Rtsbasic RC-Monster England! Offline Posts: 425 Join Date: Jun 2005 Location: North Devon, England	12.29.2005, 07:01 AM captain harlock, thats a good idea..only problem is then I have no rear bumper, and even though the car weighs quite a bit it still likes to wheelie once in a while. I'm thinking about fabricating a new rear bumper out some scrap alloy so I guess I could design it to go further back, which would allow the RCM heatsink to sit there. The epoxy idea is what I was going to run with, but I don't really like the idea of getting that stuff near my motor, I tend to naff up things like that. Thanks for the suggestions guys :) I am just a bit concerned about the winding because every other picture of a feigao i've seen didn't have the winding poking up there, normally its flush with the rest of it.