RC-Monster Forums - View Single Post - Looking at some brushless servo

Gee · 06.16.2009, 03:43 PM

Thanks. It doesn't show the amp most of the time too low I suppose. I do have it hooked so I could keep on eye on the volts. With the lipo installed all my problems or questions above are now gone or forgotten. The lipo lasted the whole time I was out running this time. It was around 8 or 9 tanks and it voltage went from 8.4 to 7.6v

Here's a different but similar question that I may as well keep in this thread.

Any ideas why Futatba has thier brushless servos listed as using only NiCd batteries with them?

Here's a link to thier brushless servos. Only one of the servo say anything about lipo or Nihm the others say NiCd only. Maybe they haven't updated the template they use for servo description since 1975. lol
http://www.futaba-rc.com/servos/brushlessservos.html
BLS351
BLS352
BLS452

Were the ones I was looking at. I sent a e-mail to futaba tech support. I've never gotten a fast response before.

	(#7)
Gee A Horse's Ass Offline Posts: 1,065 Join Date: Oct 2007 Location: Spokane WA	06.16.2009, 03:43 PM Thanks. It doesn't show the amp most of the time too low I suppose. I do have it hooked so I could keep on eye on the volts. With the lipo installed all my problems or questions above are now gone or forgotten. The lipo lasted the whole time I was out running this time. It was around 8 or 9 tanks and it voltage went from 8.4 to 7.6v Here's a different but similar question that I may as well keep in this thread. Any ideas why Futatba has thier brushless servos listed as using only NiCd batteries with them? Here's a link to thier brushless servos. Only one of the servo say anything about lipo or Nihm the others say NiCd only. Maybe they haven't updated the template they use for servo description since 1975. lol http://www.futaba-rc.com/servos/brushlessservos.html BLS351 BLS352 BLS452 Were the ones I was looking at. I sent a e-mail to futaba tech support. I've never gotten a fast response before.