That'll do nicely, cheers!
So, Mike read my mind and stole one of my CD mounting ideas I see. If you ran a smaller spur (assuming you could), and maybe cut a slot in the chassis tray, you could perhaps lower the whole CD unit a little bit more. I like it alot though, very clean and incredibly simple- I wouldnt mind notching the insides of the X-braces to run a larger spur either, its such a clean and symterical layout it makes me all warm and fuzzy inside just looking at it.
Looking forward to more pics, especially some side profile ones when you get the motor installed, gotta see just how low that motor can go, and how much clearance their is between spur and chassis plate/rails...
PS, how much did the CD unit cost just out of interest?