RC-Monster Forums - View Single Post

Snipin_Willy · 06.27.2009, 04:18 PM

I wanted to clean up the wiring a little bit before my lipos get here. I ran the bec and esc wires through a small hole in the battery box to go around the center diff rather than over it. Standard sized soft lipos shouldn't have a problem fitting in while laying flat. I'm still trying to figure out what to do with the power switch, it's ugly with the wires hanging over the rear center drive shaft. I also modded some scrap body post and put them on the front tower, I was tired of only have 1 unbroken body post.

	(#95)
Snipin_Willy RC-Monster Carbon Fiber Offline Posts: 406 Join Date: Aug 2008	06.27.2009, 04:18 PM I wanted to clean up the wiring a little bit before my lipos get here. I ran the bec and esc wires through a small hole in the battery box to go around the center diff rather than over it. Standard sized soft lipos shouldn't have a problem fitting in while laying flat. I'm still trying to figure out what to do with the power switch, it's ugly with the wires hanging over the rear center drive shaft. I also modded some scrap body post and put them on the front tower, I was tired of only have 1 unbroken body post.