ahhhhhhhhhhhhh!!!! i get ya now :o -lol-
Except one thing.....
The servo is laying totally flat on the chassis, so it wont actually allow clearance for the arm to be positioned that way....

But this gives me a thought...... Maybe i can mount the servo higher on those 2 mounts there.....

See how i'm using the upper two holes in the servo tabs? maybe i could use the lower holes in the tabs....might need higher mounts to give it some support tho, otherwise, only like, half of the servo tabs are actually held in position - is that right? do you think it would need extra support? (assuming kinda so?)

sorry - i was being confused earlier - it's quite hard explaining things to me without pics tho - i'm one of those 'gotta see it to understand it' ppl -lol- Thanks guys :D