RC-Monster Forums - View Single Post - brushless 1/5 4wd conversion about to begin! couple questions.

MetalMan · 07.03.2009, 12:53 PM

Just to throw it out there: my XLB (1/7 4wd 15lb center diff buggy) now runs a 1521 2Y on 10s 3700mah Lipo through a HV-110. It's geared for mid to low 40s but it pushes out over 5hp on peaks (loads of power). The HV-110 heats up to about 120-130deg. after maybe 10mins. I'm sure things would cool down a bit if I played with the ESC settings but this might give you an idea of what to expect from an ESC.

	(#60)
MetalMan RC-Monster Mod Offline Posts: 5,297 Join Date: Mar 2005 Location: SoCal	07.03.2009, 12:53 PM Just to throw it out there: my XLB (1/7 4wd 15lb center diff buggy) now runs a 1521 2Y on 10s 3700mah Lipo through a HV-110. It's geared for mid to low 40s but it pushes out over 5hp on peaks (loads of power). The HV-110 heats up to about 120-130deg. after maybe 10mins. I'm sure things would cool down a bit if I played with the ESC settings but this might give you an idea of what to expect from an ESC. SH Z-Car, Custom Crawler, 8s Savage, 12s XTM XLB 1/7 buggy, 4wd 4-link rear/IFS Pro4 truck, Custom Hyper 10 Short Course, Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz