RC-Monster Forums - View Single Post - Can anybody tell me if these will fit? (17mm extensions)

R00ST · 07.03.2009, 02:43 PM

Well that amount of extension is nothing (its only extended little less than a half inch). Granted there is more straing (more leverage) on the axles/carrier than stock, im willing to deal with that.

Plus 1/8 buggy carriers/axles are quite beefy so those huge bearings will not have a problem.

I run the integy adaptors on my rustler (which extend the front 1 1/2 inch and the rears about an inch) and have not had a problem yet. And the rustler uses tiny cheap axles compared to buggy parts.

Thanks for looking out though! I think im just going to bid and hope they fit.

	(#1)
R00ST RC-Monster Carbon Fiber Offline Posts: 284 Join Date: Jun 2005	07.03.2009, 02:43 PM Well that amount of extension is nothing (its only extended little less than a half inch). Granted there is more straing (more leverage) on the axles/carrier than stock, im willing to deal with that. Plus 1/8 buggy carriers/axles are quite beefy so those huge bearings will not have a problem. I run the integy adaptors on my rustler (which extend the front 1 1/2 inch and the rears about an inch) and have not had a problem yet. And the rustler uses tiny cheap axles compared to buggy parts. Thanks for looking out though! I think im just going to bid and hope they fit.