RC-Monster Forums - View Single Post - MBX5-truggy conversion, little advise

ronnyboy · 07.07.2009, 02:14 PM

thanks for the servo-thing.

like i said, too much power can be adjusted down, whereas too little will have a chance in not satisfying my needs.

i currently run a feigao 8xl (2084kv i tought?) on a 4s 6000, with a quark monster pro at a bigscale track. didnt drive too much to really see what it can do, but it looked a bit too much. cant go full throttle on the straight...

as for the tekin: a higher kv means higer speeds, but also higher temps...
i tried brianG calculator but with a 1700kv it seems to do only in the 30+ mph region? and below that with my 4s setup.
seems a bit slow, but ive never seen a slow brushless before, haha.

Can i ask what your running temps are?

	(#3)
ronnyboy www.mrcz.nl Offline Posts: 20 Join Date: Aug 2008 Location: Netherlands	07.07.2009, 02:14 PM thanks for the servo-thing. like i said, too much power can be adjusted down, whereas too little will have a chance in not satisfying my needs. i currently run a feigao 8xl (2084kv i tought?) on a 4s 6000, with a quark monster pro at a bigscale track. didnt drive too much to really see what it can do, but it looked a bit too much. cant go full throttle on the straight... as for the tekin: a higher kv means higer speeds, but also higher temps... i tried brianG calculator but with a 1700kv it seems to do only in the 30+ mph region? and below that with my 4s setup. seems a bit slow, but ive never seen a slow brushless before, haha. Can i ask what your running temps are?