RC-Monster Forums - View Single Post - brushless 1/5 4wd conversion about to begin! couple questions.

nitrostarter · 07.23.2009, 03:24 PM

Well the cooling plates are inbetween layers of boards sitting on top PLENTY of FET's. He would have to unsolder the layers to pull the cooling plates out.

I think it will be fine. I don't think your amp draw will be as much as the controller is rated for. SO i don't see it being a problem. The cooling plates are ALU as well so they will inturn act as heatsinks anyways.

	(#207)
nitrostarter RC-Monster Brushless Offline Posts: 3,156 Join Date: Jul 2005 Location: Gramercy, LA	07.23.2009, 03:24 PM Well the cooling plates are inbetween layers of boards sitting on top PLENTY of FET's. He would have to unsolder the layers to pull the cooling plates out. I think it will be fine. I don't think your amp draw will be as much as the controller is rated for. SO i don't see it being a problem. The cooling plates are ALU as well so they will inturn act as heatsinks anyways. N. Rustler conversion