RC-Monster Forums - View Single Post - Who follows the 1" per rev. gearing rule (rollout ratio)?

BrianG · 08.03.2009, 01:22 AM

It should be easy enough to do. I was thinking of adding it in one of two ways:

1: Create a new page. Enter the pertinent info and it will spit out the right pinion to use.

2: In the top speed estimator page. This page is more for calculating top speed for a specific gearing, but there is a little pinion table (by clicking the gears icon) where I could indicate the 1:1 rollout pinion somehow.

	(#7)
BrianG RC-Monster Admin Offline Posts: 14,609 Join Date: Nov 2005 Location: Des Moines, IA	08.03.2009, 01:22 AM It should be easy enough to do. I was thinking of adding it in one of two ways: 1: Create a new page. Enter the pertinent info and it will spit out the right pinion to use. 2: In the top speed estimator page. This page is more for calculating top speed for a specific gearing, but there is a little pinion table (by clicking the gears icon) where I could indicate the 1:1 rollout pinion somehow.