RC-Monster Forums - View Single Post

J57ltr · 08.26.2009, 01:37 PM

We use them a lot for little drive componets, then I found out where they get their pullies made so we use them now. SDPSI is great but expensive. We use a 15 tooth .080" pitch drive pulley and a 30 tooth for our conveyor. Boring the pulley to fit a 5mm shaft is easy, but make sure you use a drill bit that MEASURES .196",most are undersized or over sized, even metric drills are this way so watch out.

Jeff

	(#6)
J57ltr RC-Monster Aluminum Offline Posts: 610 Join Date: Feb 2009 Location: Tomball/ Houston Tx.	08.26.2009, 01:37 PM We use them a lot for little drive componets, then I found out where they get their pullies made so we use them now. SDPSI is great but expensive. We use a 15 tooth .080" pitch drive pulley and a 30 tooth for our conveyor. Boring the pulley to fit a 5mm shaft is easy, but make sure you use a drill bit that MEASURES .196",most are undersized or over sized, even metric drills are this way so watch out. Jeff The Warnings & Cautions discussed in this manual cant cover all possible conditions/situations. It must be understood that common sense and caution are factors which cant be built into this product.