RC-Monster Forums - View Single Post

BrianG · 09.08.2009, 01:42 PM

Sounds like it was pulling too much current and went into thermal runaway. The tighter mesh could have had something to do with it, but would think it would have to be pretty tight to cause that.

Also, did you change any of the settings? IIRC, setting 0 punch and/or 0 timing does cause problems...

	(#2)
BrianG RC-Monster Admin Offline Posts: 14,609 Join Date: Nov 2005 Location: Des Moines, IA	09.08.2009, 01:42 PM Sounds like it was pulling too much current and went into thermal runaway. The tighter mesh could have had something to do with it, but would think it would have to be pretty tight to cause that. Also, did you change any of the settings? IIRC, setting 0 punch and/or 0 timing does cause problems...