|
10.06.2009, 07:27 PM
That's good to know that your rebonded rotors have been holding up. I haven't tested either of my rebonds, but I think I did a solid job and used Loctite 603. Loctite 603 is a higher bond strength than 609 and a bit more heat resistant, but I'm sure either will work. On my first bad rotor I did not notice any sticky residue from the original assembly, but on my second there was some, but not much.
E-CRT.5 Monster - RCM chassis, MM/Medusa 50x3300/3s, truck tires, 1/8 shocks
E-CRT.5 Stock - Sidewinder/4600/2s, buggy tires
E-8ight - Tekin RX8 2000kv/4S
E-8ight T- Tekin RX8 1700kv/5S
|