RC-Monster Forums - View Single Post - High speed G-maxx for ISC event, 100mph or bust

Rivermaxx · 12:44 PM

No bearing in the front. It just fits in place of the whole slipper assembly on the input shaft which is supported by bearings. There is a step up where the center bearing would be to center the gear on the adaptor. It does look to be a very simple straight foward design. For $17 shiped I couldn't pass it up. It would cost me 5 times that amount to make a similar item.

	(#163)
Rivermaxx RC-Monster Aluminum Offline Posts: 638 Join Date: Sep 2008	11.04.2009, 12:53 PM No bearing in the front. It just fits in place of the whole slipper assembly on the input shaft which is supported by bearings. There is a step up where the center bearing would be to center the gear on the adaptor. It does look to be a very simple straight foward design. For $17 shiped I couldn't pass it up. It would cost me 5 times that amount to make a similar item. Last edited by Rivermaxx; 11.05.2009 at 12:44 PM.