RC-Monster Forums - View Single Post

Nard Cox · 01:19 PM

Hi Neil, thanks 4 the help!!

Just put the BLUR (HPI MMM) and two 2S LiPo's on the RC8Te. Exact same problem! But now I went outside and pressed the gass a little harder and what do you know, it drives. Slow driving is no problem but when I want to accelerate it start up again. Now I will install the Flux motor in the RC8Te (also just to test if it's fit and how it performs). But the problem seems to be isolated in the motor. Will try to open up the motor on the end.

Ok, so the Flux motor doesn't fit the truggy. I had to raise the centerdiff 2mm just to fit the Neu and that's a tight fit. But the Flux motor has a bigger diameter, the Neu (F version) is 44mm and the Flux motor is 48. Will try to open up the motor now. Will my guarantee expire by doing this?

	(#9)
Nard Cox n00b Offline Posts: 519 Join Date: Apr 2009 Location: The Netherlands	11.28.2009, 01:11 PM Hi Neil, thanks 4 the help!! Just put the BLUR (HPI MMM) and two 2S LiPo's on the RC8Te. Exact same problem! But now I went outside and pressed the gass a little harder and what do you know, it drives. Slow driving is no problem but when I want to accelerate it start up again. Now I will install the Flux motor in the RC8Te (also just to test if it's fit and how it performs). But the problem seems to be isolated in the motor. Will try to open up the motor on the end. Ok, so the Flux motor doesn't fit the truggy. I had to raise the centerdiff 2mm just to fit the Neu and that's a tight fit. But the Flux motor has a bigger diameter, the Neu (F version) is 44mm and the Flux motor is 48. Will try to open up the motor now. Will my guarantee expire by doing this? Last edited by Nard Cox; 11.28.2009 at 01:19 PM.