RC-Monster Forums - View Single Post

George16 · 11.28.2009, 06:21 PM

Using the included 13T mod1 pinion did not work well due to the size of the motor. I had to put 3mm spacers underneath the ESC mount so the motor can clear it. This was the refurb ESC I bought from Castle back in August. The power wires were soldered into the bullet probably by someone who does not really want to do it.

Turned the CC 6.5mm bullets into angled ones by enlarging the hole on the side. Turned up pretty well

.

I installed this little plastic screen on top of the fan. It's held in place by the traxxas ESC mount.

	(#3)
George16 Supermaxx Offline Posts: 2,031 Join Date: Oct 2007 Location: Earth	11.28.2009, 06:21 PM Using the included 13T mod1 pinion did not work well due to the size of the motor. I had to put 3mm spacers underneath the ESC mount so the motor can clear it. This was the refurb ESC I bought from Castle back in August. The power wires were soldered into the bullet probably by someone who does not really want to do it. Turned the CC 6.5mm bullets into angled ones by enlarging the hole on the side. Turned up pretty well . I installed this little plastic screen on top of the fan. It's held in place by the traxxas ESC mount. Castle Neu 1520 on 6S LiPo Powered Gmaxx (Nitro Killer) Predator with OS .21TM Supermaxx with Mach .26 Revo with OS .18TZ Kyosho ST-RR Conversion Ofna CR with Tekin ESC/Motor (2)