RC-Monster Forums - View Single Post

sikeston34m · 11:35 PM

Just a little update here.

After running 5 or so cycles through the MM Pro in the e maxx running a HV4400 with sinter rotor/5mm shaft, it was time to move them to my E Revo.

My E Revo is setup with:

MMM ESC
Medusa 36-60-1500 geared 22/40 using Mod 1 gears.

This is more of an amp hog than the E maxx setup.

The packs handle the E Revo just fine. They have alot of punch.

I've ran them in the E Revo 4 times now. Two of those times were both in the same hour today.

20 amp charge rate.

They come out of the E Revo about 100 degrees. Still not bad, but this does show they are being pushed harder.

	(#112)
sikeston34m RC-Monster Brushless Offline Posts: 2,085 Join Date: Sep 2007	11.28.2009, 11:30 PM Just a little update here. After running 5 or so cycles through the MM Pro in the e maxx running a HV4400 with sinter rotor/5mm shaft, it was time to move them to my E Revo. My E Revo is setup with: MMM ESC Medusa 36-60-1500 geared 22/40 using Mod 1 gears. This is more of an amp hog than the E maxx setup. The packs handle the E Revo just fine. They have alot of punch. I've ran them in the E Revo 4 times now. Two of those times were both in the same hour today. 20 amp charge rate. They come out of the E Revo about 100 degrees. Still not bad, but this does show they are being pushed harder. Last edited by sikeston34m; 11.28.2009 at 11:35 PM.