RC-Monster Forums - View Single Post

BrianG · 12.18.2009, 02:20 AM

I don't think anything could go wrong unless someting conductive happens to short across those connections. But, I just don't like esposed wires; seems unfinished.

The pen caps are just to see how well it works. Easy to make; a little dremel work and they just snap on and off. I don't pics of this exact setup, but aside from the motor, it's the same as the old pics of my XT8 (in my conversions page in sig) just a different motor.

Actually, the original rotor is still in the motor. I figured I would see if it holds up before I swapped it for the newer one that was included in the box. So far so good.

	(#3)
BrianG RC-Monster Admin Offline Posts: 14,609 Join Date: Nov 2005 Location: Des Moines, IA	12.18.2009, 02:20 AM I don't think anything could go wrong unless someting conductive happens to short across those connections. But, I just don't like esposed wires; seems unfinished. The pen caps are just to see how well it works. Easy to make; a little dremel work and they just snap on and off. I don't pics of this exact setup, but aside from the motor, it's the same as the old pics of my XT8 (in my conversions page in sig) just a different motor. Actually, the original rotor is still in the motor. I figured I would see if it holds up before I swapped it for the newer one that was included in the box. So far so good.