RC-Monster Forums - View Single Post - 4wd Corr/Pro-4 Truck REDESIGN POSTED 12/23/09

MetalMan · **HUGE Redesign/Rebuild -** 12.23.2009, 06:17 PM

Hey all,
This truck underwent an entire rebuild of the chassis, where the CG was dropped significantly. Instead of an outrunner it now has a Medusa 36-60-1600 (from my Jammin' X1-CRT) and a slipper clutch using a MT2 slipper shaft and Revo slipper clutch components. With the redesign the driveshaft angles are much better and the lower link mounting is a lot stronger.

I had already driven it but decided it would be a good idea to tear it down and do a little cleaning, so here are the build pictures:

	(#87)
MetalMan RC-Monster Mod Offline Posts: 5,297 Join Date: Mar 2005 Location: SoCal	HUGE Redesign/Rebuild - 12.23.2009, 06:17 PM Hey all, This truck underwent an entire rebuild of the chassis, where the CG was dropped significantly. Instead of an outrunner it now has a Medusa 36-60-1600 (from my Jammin' X1-CRT) and a slipper clutch using a MT2 slipper shaft and Revo slipper clutch components. With the redesign the driveshaft angles are much better and the lower link mounting is a lot stronger. I had already driven it but decided it would be a good idea to tear it down and do a little cleaning, so here are the build pictures: SH Z-Car, Custom Crawler, 8s Savage, 12s XTM XLB 1/7 buggy, 4wd 4-link rear/IFS Pro4 truck, Custom Hyper 10 Short Course, Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz