RC-Monster Forums - View Single Post - successfully took out the bad cell on my lipo.. now what?

BrianG · 02.22.2010, 03:21 AM

Refer to the picture below:

1: Completely remove the black wire with the red X from the connector.

2: Move the red wire to where the black wire was.

3: Solder the end of the red wire to the lipo tab where the main + wire is.

	(#7)
BrianG RC-Monster Admin Offline Posts: 14,609 Join Date: Nov 2005 Location: Des Moines, IA	02.22.2010, 03:21 AM Refer to the picture below: 1: Completely remove the black wire with the red X from the connector. 2: Move the red wire to where the black wire was. 3: Solder the end of the red wire to the lipo tab where the main + wire is. Attached Thumbnails