I just bought a new align servo for my 10th scale rt5 its model DS610 i connected it to my mmp and the reciever started to lose power when turning fast. This is with no load on the servo. I also have a JR 9100 high torque servo which i tried on the mmp and had no problems, this was just to test the BEC with a known trouble servo. So at this point i assumed I had a bad servo but when i connect it to the rx8 in my 8ight it works fine. This servo is smaller than my JR and does not have nearly the torque. What is going on? Was the fix mentioned earlier in this thread about adding a delay ever implemented in new mmps. Should I send the mmp in?