|
03.07.2010, 09:46 PM
The only way an existing mount (not made for XTM) will work is if fastlane01 also gets the center bulkhead made for the same vehicle the mount is. XTM 1/8 uses center bulkheads with an offset center bearing hole.
SH Z-Car, Custom Crawler, 8s Savage, 12s XTM XLB 1/7 buggy, 4wd 4-link rear/IFS Pro4 truck, Custom Hyper 10 Short Course, Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz
|