RC-Monster Forums - View Single Post - Maximizer X75 Maxx adapters for Nitro Stampede

Rusty4Ever · 10:36 PM

I realize this is a pre-sale forum; but I ordered these today for my electric Stampede today (with Nitro front spindle conversion).

Now it shows item is now unavailable; did my order cause this? I've not gotten an email response yet.

I specified in the comments I wanted the Nitro Stampede version to fit the Maxx wheels, & I believe it's correct for my application; tho it's electric, I have front Nitro spindles & have done the "wide" conversion to the front & will be using RPM's StableMaxx offset rims. I should be fine right?

The picture is confusing to me, I see the rear hex drives clear enough, the front bearing/spindle is less clear; do these fit inside the Maxx wheel hex??
EDIT: On Maximizer's website, it appears the front pieces hold the 5x11 bearings on both sides of the Maxx rim so the fronts spin without wobble. Hope I get sent the correct Nitro part, will probably want to get the Fastlane extended chassis too. :024:

Thanks for any help with this. Great site/products by the way :027: Wish I would have found it earlier :007:

	(#1)
Rusty4Ever RC-Monster Not Stock Offline Posts: 32 Join Date: Feb 2006 Location: Boca Raton, Fl	Maximizer X75 Maxx adapters for Nitro Stampede - 02.13.2006, 09:54 PM I realize this is a pre-sale forum; but I ordered these today for my electric Stampede today (with Nitro front spindle conversion). Now it shows item is now unavailable; did my order cause this? I've not gotten an email response yet. I specified in the comments I wanted the Nitro Stampede version to fit the Maxx wheels, & I believe it's correct for my application; tho it's electric, I have front Nitro spindles & have done the "wide" conversion to the front & will be using RPM's StableMaxx offset rims. I should be fine right? The picture is confusing to me, I see the rear hex drives clear enough, the front bearing/spindle is less clear; do these fit inside the Maxx wheel hex?? EDIT: On Maximizer's website, it appears the front pieces hold the 5x11 bearings on both sides of the Maxx rim so the fronts spin without wobble. Hope I get sent the correct Nitro part, will probably want to get the Fastlane extended chassis too. :024: Thanks for any help with this. Great site/products by the way :027: Wish I would have found it earlier :007: Last edited by Rusty4Ever; 02.13.2006 at 10:36 PM.