RC-Monster Forums - View Single Post - Project : Mugen MBX6-T Racer

itbvolks · 03.31.2010, 09:41 PM

Wallot,

Curious how you've found the aluminum drive cups to work (not sure if you ran them on your MBX5T setup)?

Picked up a set for my racer and hoping they hold together reasonably well. Clearly a nice light setup with regards to the rotating mass of the driveline. Hoping it actually translates to quicker spool, less heat, less driveline loss.

Truck looks great. I'll agree, I prefer Mikes mount for the lower CG. I'm omitting using Mike's servo tray (like you have) so I can mount my transponder/Rx lower in the chassis. Need to see how it works out.

Curious what gearing your running? I went with 16/46 with my Tekin 1700kv setup. I'll be running this on Hyperion 5S (still working on capacity).

	(#22)
itbvolks RC-Monster Carbon Fiber Offline Posts: 119 Join Date: Mar 2010	03.31.2010, 09:41 PM Wallot, Curious how you've found the aluminum drive cups to work (not sure if you ran them on your MBX5T setup)? Picked up a set for my racer and hoping they hold together reasonably well. Clearly a nice light setup with regards to the rotating mass of the driveline. Hoping it actually translates to quicker spool, less heat, less driveline loss. Truck looks great. I'll agree, I prefer Mikes mount for the lower CG. I'm omitting using Mike's servo tray (like you have) so I can mount my transponder/Rx lower in the chassis. Need to see how it works out. Curious what gearing your running? I went with 16/46 with my Tekin 1700kv setup. I'll be running this on Hyperion 5S (still working on capacity).