RC-Monster Forums - View Single Post - How to remove bearing from the rear endbell ?

nuz69 · 04.29.2010, 05:24 AM

Same here, in my 1520 and 1515, i can push the rotor in the motor, and then the rotor comes back with magnet force on the front bearing. I always wondered if it don't apply too much strains ont the front bearing, but all seems OK.
Dont forget to glue your bearings ! My front bearing was unglued and moving in the front bell, the are glued stock.

	(#7)
nuz69 RC-Monster Carbon Fiber Offline Posts: 471 Join Date: Feb 2010	04.29.2010, 05:24 AM Same here, in my 1520 and 1515, i can push the rotor in the motor, and then the rotor comes back with magnet force on the front bearing. I always wondered if it don't apply too much strains ont the front bearing, but all seems OK. Dont forget to glue your bearings ! My front bearing was unglued and moving in the front bell, the are glued stock.