RC-Monster Forums - View Single Post

Nard Cox · 11:47 AM

Hi guys,

I bought myself a RCM Slipperential via eBay (turned out it was from Bryan here). Now I got it but there is a big wobble in the output yokes (Bryan mentioned this in his ad). So I was just curious what I should replace:

I put together a small movie for you to check the play:

[YOUTUBE]Q54veG7vc7g[/YOUTUBE]

I'm guessing it are the two end cap plates that are worn out? I've read Mike made some hardend steel versions that should ''last forever''?

Thanks guys!

EDIT: Any other hints on what would need replacement while rebuilding, some gaskets and o-rings?

	(#1)
Nard Cox n00b Offline Posts: 519 Join Date: Apr 2009 Location: The Netherlands	What needs replacing?? - 06.26.2010, 11:30 AM Hi guys, I bought myself a RCM Slipperential via eBay (turned out it was from Bryan here). Now I got it but there is a big wobble in the output yokes (Bryan mentioned this in his ad). So I was just curious what I should replace: I put together a small movie for you to check the play: [YOUTUBE]Q54veG7vc7g[/YOUTUBE] I'm guessing it are the two end cap plates that are worn out? I've read Mike made some hardend steel versions that should ''last forever''? Thanks guys! EDIT: Any other hints on what would need replacement while rebuilding, some gaskets and o-rings? Mugen MBX6Te RCM + Mugen MBX6e RCM + Savage Flux XL FLM + MERV all with Spectrum DX3S \|\| WTS&WTB Last edited by Nard Cox; 06.26.2010 at 11:47 AM.