RC-Monster Forums - View Single Post

Scott711 · 02.21.2006, 05:27 PM

To pop off the bell end (the end in your pics) just tap on the other end of the shaft with a piece of wood or something that won't damage the shaft. That will pop the end bell off and should allow you to re-position the opening. I used the opportunity to gently file down the edges of the opening and then I painted on some loctite rubber coating to re-insulate my wires. I had the same issue as you where the insulation wore through and went to ground on the can. Good luck.

	(#3)
Scott711 RC-Monster Carbon Fiber Offline Posts: 116 Join Date: Nov 2005 Location: DesMoines, WA	02.21.2006, 05:27 PM To pop off the bell end (the end in your pics) just tap on the other end of the shaft with a piece of wood or something that won't damage the shaft. That will pop the end bell off and should allow you to re-position the opening. I used the opportunity to gently file down the edges of the opening and then I painted on some loctite rubber coating to re-insulate my wires. I had the same issue as you where the insulation wore through and went to ground on the can. Good luck.