Quote:
Originally Posted by bruce750i
Yes, Having less contact area will increase the chance of stripping. I use them on lower torque applications. I would not use one to set a pinion grub screw. Also sometimes I'll place the bolt on my hex driver first then take it to the hole, you can't do that with ball drivers. I use the ball-tip set from bondhus too.
I prefer to have both on hand, but in a jam I'll take Non-ball.
|
Well said...I use both as well..ball tips for less torque
1. MBX-6 T8 1900KV, RX8 ON 4S
2. MBX-5T 1520, MMM ON 5S
3. MBX-5 ONROAD CONVERSION 1515, MMM ON 5S
4. MRX-3 ON ROAD CONVERSION 1512, MMM ON 6S
5. TEN T 2650 T8, MMP ON 3S