RC-Monster Forums - View Single Post - Hex drivers: regular vs. ball-tip

Bondonutz · 11.11.2010, 06:29 PM

Ditto for me also, I use the straight tips for tightening and losening or a "L" angle then use the ball tips for hard to reach spots to run the screws in or out.

If a choice of one or the other, Straight tip every time.

	(#8)
Bondonutz Fat Kid Engineering Offline Posts: 3,634 Join Date: Jun 2009 Location: Hot as Hell West Central Coast Florida	11.11.2010, 06:29 PM Ditto for me also, I use the straight tips for tightening and losening or a "L" angle then use the ball tips for hard to reach spots to run the screws in or out. If a choice of one or the other, Straight tip every time. I retired from RC, now life is all about guns and long range shooting.