RC-Monster Forums - View Single Post

Kcaz25 · 11:54 PM

I have a spare set actually that has maybe 5 runs on it. I would love to have a set made. I can get it to you.

I have an note to make. I was sitting around with my cousin home for Thanksgiving who has an 8t 1.0 and we were discussing my true-tracks and how when setup for high ground clearance bashing the shafts can pop out of the cups for a number of reasons when I asked him to remove his rear tires so that I could have a look at his rear suspension. I took it apart and we put the rear carriers on my True-Track and it fit Losi shafts and everything... and its seated well in the cup. I'm pretty excited its much cheaper than going with RacerX but the rear trackwidth(is that term right) comes up alittle narrow. I think it could be made up though with slightly extended hexes. I'm not sure what I'm trying to say but I request that if done you must allow the system to work better with steel shafts. Lets make it beefy enough that we can use a truck buckle like on a truggy as well for the top arm.

I'll get a picture of the trucks we had over for Thanksgiving and closer to Christmas time I'll get some pictures of the truck with the Losi parts.

-Zack

	(#7)
Kcaz25 RC-Monster Titanium Offline Posts: 1,419 Join Date: Dec 2008 Location: Louisville, KY	12.05.2010, 11:51 PM I have a spare set actually that has maybe 5 runs on it. I would love to have a set made. I can get it to you. I have an note to make. I was sitting around with my cousin home for Thanksgiving who has an 8t 1.0 and we were discussing my true-tracks and how when setup for high ground clearance bashing the shafts can pop out of the cups for a number of reasons when I asked him to remove his rear tires so that I could have a look at his rear suspension. I took it apart and we put the rear carriers on my True-Track and it fit Losi shafts and everything... and its seated well in the cup. I'm pretty excited its much cheaper than going with RacerX but the rear trackwidth(is that term right) comes up alittle narrow. I think it could be made up though with slightly extended hexes. I'm not sure what I'm trying to say but I request that if done you must allow the system to work better with steel shafts. Lets make it beefy enough that we can use a truck buckle like on a truggy as well for the top arm. I'll get a picture of the trucks we had over for Thanksgiving and closer to Christmas time I'll get some pictures of the truck with the Losi parts. -Zack Last edited by Kcaz25; 12.05.2010 at 11:54 PM.