RC-Monster Forums - View Single Post

outlaw · 11:20 AM

100% undergeared ! Those Motors don't care much about gearing
We had a test with the /7 on MMP in a SC8 compared to the CC2200 Motor (same KV)
The /7 does take 15-19 pinon and does not care ;-)
On higher timing, you will see less temps !
BTW the magnets can handle up to 180 degrees ! on all of them

10 degrees was just a test, i will go back to 18-20. But without Sensor, the MMP can't do more than 20.

I wish a 2240/10 would come around my house... compare 3S to 6S

Castle, maybe this would be a welcome change for the firmware, to allow maybe 25 degrees of timing, without sensor

	(#14)
outlaw Castle addicted Offline Posts: 146 Join Date: Dec 2010 Location: Hamburg, Germany	01.04.2011, 08:17 AM 100% undergeared ! Those Motors don't care much about gearing We had a test with the /7 on MMP in a SC8 compared to the CC2200 Motor (same KV) The /7 does take 15-19 pinon and does not care ;-) On higher timing, you will see less temps ! BTW the magnets can handle up to 180 degrees ! on all of them 10 degrees was just a test, i will go back to 18-20. But without Sensor, the MMP can't do more than 20. I wish a 2240/10 would come around my house... compare 3S to 6S Castle, maybe this would be a welcome change for the firmware, to allow maybe 25 degrees of timing, without sensor kind regards Mirko Brushless motors have to be green .... Last edited by outlaw; 01.04.2011 at 11:20 AM.