RC-Monster Forums - View Single Post - Need help with my G3-build

George16 · 02.05.2011, 06:13 PM

I've had luck using ejector pins cut to length as hinge pins. I also had it captured by cutting a mortise into the pin and drilled/tapped a 3mm hole into the bulkhead so a setscrew can hold it in place..

You can check my gmaxx build here:

	(#130)
George16 Supermaxx Offline Posts: 2,031 Join Date: Oct 2007 Location: Earth	02.05.2011, 06:13 PM I've had luck using ejector pins cut to length as hinge pins. I also had it captured by cutting a mortise into the pin and drilled/tapped a 3mm hole into the bulkhead so a setscrew can hold it in place.. You can check my gmaxx build here: Castle Neu 1520 on 6S LiPo Powered Gmaxx (Nitro Killer) Predator with OS .21TM Supermaxx with Mach .26 Revo with OS .18TZ Kyosho ST-RR Conversion Ofna CR with Tekin ESC/Motor (2)