[lincpimp]

Thanks, I have been "mentally designing" it for a few weeks. I like to type out my plans so I can go over them. Plus i tend to get stuff figured out and then forget it, so it is good to have notes!

I think the tranny plates will be something quite thick, like 10mm al, possibly 7075 as the weight of the motor will be on one of them. Depending on space I may tie them together with a few stand offs, so I can remove the tranny as a unit if needed.

I am selling of stuff so I can pick up the truck, then I will sell of the nitro stuff and gather the other required parts from the ebay chop shops. I found a few parts last night that were way cheap so I picked them up.