RC-Monster Forums - View Single Post

Nixpus · 11:05 AM

The wide hub will be made by my tool shop colleague. A wide front knuckle is also in the works. We'll only be doing two sets... but the idea is free to copy :)

Im still messing about with my ultra low CoG layout... might do cut outs in the TVP's to have the batteries sit horizontally just above a wide skid plate.

I actually think I could fit the 1717 in on the side of the servo like you did. Not a bad idea! The motor mounting is also smart... but may take too much space.

	(#26)
Nixpus RC-Monster Carbon Fiber Offline Posts: 138 Join Date: May 2009 Location: Denmark	03.09.2011, 11:03 AM The wide hub will be made by my tool shop colleague. A wide front knuckle is also in the works. We'll only be doing two sets... but the idea is free to copy :) Im still messing about with my ultra low CoG layout... might do cut outs in the TVP's to have the batteries sit horizontally just above a wide skid plate. I actually think I could fit the 1717 in on the side of the servo like you did. Not a bad idea! The motor mounting is also smart... but may take too much space. Last edited by Nixpus; 03.09.2011 at 11:05 AM.